1.Multi-dog training system
2.Expandable to three-dog operation
3.review dog training collars
4.remote rang is 1000 meter

100 level with lcd display multi-review dog training collars for 1~3 Dog-1000M

CONNECT YOUR TRANSMITTER WITH YOUR RECEIVERS

Before using this system, please connect your transmitter with your receivers.

1. Install the battery(1x6F22/9V) in the transmitter and ensure the polarity is correct.

2. Adjust the channel button to the right one you want to stay.

3. Install the batteries(2xAAA 1.5V) in the receiver(please refer to how to install the batteries

in receivers)

4. There is a beep right after installing the batteries.

5. After hearing the beep, you should press the launch button from the transmitter to encode

the transmitter and the receiver immediately. There is a beep again from the receiver if you

encode successfully.

6. If there is no response from the receiver, reinstall the batteries from the receiver and press

launch button again.

7. This system could train up to 3 dogs at the same time. To encode different dogs, just change to

different channel and repeat the procedure as described again.

HOW TO INSTALL BATTERIES IN THE RECEIVER

The batteries hides in the back of the unit, you need to take off the belt first.

Please refer to the pictures and follow these step by step:

HOW TO USE THIS SYSTEM

Introduction for the transmitter

There are 7 buttons in the the transitter.

Channel button( up to 3 channels)

Mode button (sound, vibration and shock)

M1 memory group button(up to 3 memories)

M2 memory set button

Level buttons (Up and Down)

Launch button

Basical operation

To install the batteries, open the battery cover at the back of the transmitter.

Install the battery (1 x6F22/9V) - ensure the polarity is correct.

The transmitter will be TURN ON automatically.

Press Mode button to choice the different mode(sound, vibration and static shock) and press the

UP/Down button on right hand side to set level.

Notes: These three modes could be combined freely, so please set those modes

you don't want at the level “ 0 ” .

Memory function

Press M1 button to choice the memory group

Adjust the right levels for each mode and press M2 to set the memory

There are 3 memory groups for each channel

Power Saving function for the transmitter and receiver

The transmitter will go into STANDBY MODE if not operated for 2 minutes (the LCD screen is off) and will TURN OFF if not operated for 5 minutes.

In STANDBY MODE, press mode button to wake it up.

To TURN ON the transmitter, hold mode button at least 3 seconds.

The receiver will turn into sleep mode if it is unused for 4 minutes.

Any movement will activate the receiver into the working mode